iwconfig run again after shows the essid still as "off/any". If I use iwevent, I can see the essid set event appear, but it never "takes". Tx excessive retries:0 Invalid misc:0 Missed beacon:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Link Quality:0 Signal level:0 Noise level:0 Mode:Managed Channel:0 Access Point: 00:00:00:00:00:00Įncryption key:XXXX-XXXX-XXXX-XXXX-XXXX-XXXX-XX Security mode:restricted
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 Wlan0 Link encap:Ethernet HWaddr 00:0F:B5:F4:69:85 TX packets:1500 errors:0 dropped:0 overruns:0 carrier:0 RX packets:1500 errors:0 dropped:0 overruns:0 frame:0 TX packets:5945 errors:0 dropped:0 overruns:0 carrier:0 RX packets:17787 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Wlan0: encryption modes supported: WEP TKIP with WPA, WPA2, WPA2PSK AES/CCMP with WPA, WPA2, WPA2PSKĮth0 Link encap:Ethernet HWaddr 00:14:2A:5B:C5:C2 Wlan0: ndiswrapper ethernet device 00:0f:b5:f4:69:85 using driver wg311v3, 11AB:1FAA.5.conf Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- SERR- Link -> GSI 10 (level, low) -> IRQ 10
Here's the relevant output (with the wg311v3 driver loaded):Ġ2:06.0 Ethernet controller: Marvell Technology Group Ltd.: Unknown device 1faa (rev 03)Ĭontrol: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B. However, I can't get it to accept a setting of the ESSID. I can get each driver to load successfully in ndiswrapper (one or the other, of course) and I can use ifconfig to bring the interface (wlan0) up and iwconfig to configure it most of the way (e.g. I have followed bennybben's advice about using the ndsiwrapper and I have tried both the wg311v3 driver from netgear (linked above) and the trendware mrv8000c driver suggested in bennybben's second post. There is a lack of info out there about the WG311v3 card. Please, let me know if you have running this card, and how you did it. Tested drivers: many ndiswrapper drivers,Ĭode: 11ab:1faa (rev 03) -0000:01:07.0 Ethernet controller: Marvell Technology Group Ltd. i get 'driver present' but no 'hardware present'.
0 kommentar(er)
